THE ELDREDGE KNOT.
1. Start with the wide end of the tie on the left and the
small end on the right. The tip of the wide end should rest
at the top of your belt buckle. Only move the active (small)
end.
2. Small end over the wide end to the left.
3. Under the wide end and to the right.
4. Up to the center, towards neck loop.
5. Through the neck loop and to the left.
6. Across the front, to the right. Then up into the neck loop
from underneath.
7. Down to the left and around the back of the wide end to
the right. Keep this part loose.
8. Bring it across the front towards the left and through the
loop made in the previous step.
9. Pull the small end towards the left to tighten.
10. Up to the center, towards neck loop. Down through the
neck loop and to the left.
11. Up to the center, towards neck loop. Down through the
neck loop and to the right. Keep this part loose.
12. Across the front towards the left and through the loop made in the previous step.
13. Pull the small end towards the left to tighten.
14. Tuck the rest of the small end behind neck loop on the
left side.
15. Strut your stuff.
THE TRINITY KNOT.
1. Start with the wide end of the tie on the left and the
small end on the right. The tip of the wide end should rest
at the top of your belt buckle. Only move the active (small)
end.
2. Over the wide end to the left.
3. Up into the neck loop from underneath.
4. Down to the left.
5. Around the back of the wide end to the right.
6. Up to the center, towards neck loop.
7. Through the neck loop and down to the left
8. Across the wide end to the right. Up into the neck loop
from underneath.
9. Down through the loop you created in the previous step.
Keep loose.
10. Bring the small end around the back of the wide end to
the right.
11. Bring it across the front towards the center and
through the loop created in the previous step.
12. Tighten and tuck the rest of the small end behind neck
loop on the left side.
13. Hypnotize the throngs of onlookers.
THE MURRELL KNOT.
1. Start with the small end of the tie on the right and the
wide end on the left. The tip of the wide end should rest
slightly below your belly-button (this will vary depending
on your height and the length & thickness of your tie). Only
move the active (small) end.
2. Small end over the wide end to the left.
3. Up into the neck loop from underneath.
4. Down to the left.
5. Around the back of the wide end to the right.
6. Up to the center, towards neck loop.
7. Through the neck loop and down to the right.
8. Across the front to the left.
9. Up into the neck loop from underneath.
10. Down through the loop you've just created in the front.
11. Tighten the knot by pulling down on the small end.
Slide the knot and adjust.
THE VAN WIJK KNOT.
1. Start with the wide end of the tie on the right and the
small end on the left. The tip of the small end should rest
slightly above your belly-button (this will vary depending
on your height and the length & thickness of your tie). Only
move the active (wide) end.
2. Wide end over the small end to the left.
3. Under the small end and to the right.
4. Across the front and to the left.
5. Under the small end and to the right.
6. Across the front and to the left.
7. Under the small end and to the right.
8. Across the front and to the left.
9. Up into the neck loop from underneath.
10. Down through all three loops in the front.
11. Tighten the knot by pulling down on the wide end. Slide
the knot up & adjust. The first and second loop should show slightly underneath the third loop.
0 comments:
Post a Comment